A methodology for the identication of inertial properties of small size UAVs

Francesco Schettini, Eugenio Denti, Gianpietro Di Rito

Abstract


This paper illustrates a procedure for estimating the inertial properties of small size aerial vehicles. An identification algorithm has been developed that, starting from experimental data, estimates the parameters of a physical model describing the pendular motion of a generic rigid body. The attitude time histories of a structure (“cage”), carrying the object whose inertial properties have to be evaluated, are the experimental data obtained through a measurement unit attached to the cage itself. The cage, designed in order to facilitate the assembly issues, is put in pendular motion thanks to a needle shaped pivot, placed to the cage top and leaning against a beam. Before proceeding to the identification of the aerial vehicle inertial properties, several tests have been performed to evaluate the performance of the algorithm. A preliminary effectiveness of the algorithm has been assessed via simulation environment, by artificially creating “virtual” time histories. Afterwards, the algorithm has been validated experimentally by loading the cage with a proof mass of known inertial characteristics. During these experimental tests, specific attention has been focused on the effect of the cage initial attitude on the inertial properties estimate. After this algorithm test phase, the developed methodology has been applied to a small rotary-wing UAV in order to evaluate its inertial properties.


Full Text:

PDF

References


R. V. Jategaonkar, “Flight Vehicle System Identification: A Time Domain Methodology”, AIAA - Progess in Astronautics and Aeronautics, ISBN 978-1563478369, 2006.

M. D. McEwen, “Dynamic System Identification and Modeling of a Rotary Wing UAV for Stability and Control Analysis”, Ph.D. Thesis, Naval Postgraduate School, Monterey, CA, USA, 1998.

C. L. Bottasso, F. Luraghi, G. Maisano, “Time-Domain Parameter Estimation for First-Principle Rotorcraft Models using Recursive and Batch Procedures: Formulation and Preliminary Results”, Scientific Report DIA-SR 09-05, 2009.

P. G. Hamel, V. Jategaonkar, “The Role of system identification for flight vehicle applications” - revisited in Proceeding of System Identification for Integrated Aircraft Development and Flight Testing - RTO SCI Symposium, Madrid, Spain, 1998.

C. L. Bottasso, D. Leonello, A. Maffezzoli, F. Riccardi, “A procedure for the identification of the inertial properties of small-size UAVs” in Proceeding of XX AIDAA Congress, Milan, Italy, 2009.

M. R. Jardin, E. R. Mueller, “Optimized measurements of UAV mass moment of inertia with a bifilar pendulum” in Proceeding of AIAA Guidance, Navigation and Control Conference and Exhibit, Hilton Head, SC, USA, 2007.

C. Doniselli, M. Gobbi, G. Mastinu, “Measuring the inertia tensor of vehicles”, Vehicle System Dynamics Supplement, Vol.37, pp. 301–313, 2002.

A. Fregolent, A. Sestieri, “Identification of rigid body inertia properties from experimental frequency response”, Journal of Mechanical Systems and Signal Processing, Vol.10, pp. 697–709, 1996.

A. Gentile, L. Mangialardi, G. Mantriota, A. Trentadue, “Measurement of the inertia tensor: an experimental proposal”, Journal of Measurement, Vol.16, pp. 241–254, 1995.




DOI: http://dx.doi.org/10.19249/ams.v93i3-4.113

Refbacks

  • There are currently no refbacks.


Copyright © 2018. All Rights Reserved.